TECHNICAL GUIDE
Fit & measurements
Use an existing cap, a detached sample or a buyer-owned drawing. Keep your measurement reference points visible.
Visor geometry
- Lay the peak flat without forcing its shape.
- Take a straight-on top photo beside a ruler and add a side view.
- Mark the span, centre depth, rear curve and attachment points in millimetres.
Strap geometry
- Measure width, end-to-end length and the distance between attachment centres.
- If adjustable, note shortest and longest usable lengths.
- Photograph both ends and the intended attachment on the cap.
Before sending a brief
State what must match the existing cap and what can vary. If there are several patterns or sizes, supply separate measurements for each. These diagrams illustrate measurement points, not guaranteed compatibility.
Prepare a component quote